Total suspended solids (TSS)

Two 1000mL water samples were obtained at each site prior to the deployment of benthic sampling equipment.

Laboratory Procedures:

1) Dry new filters at 60°C in the oven prior to use. 2) Weigh filter immediately before use. After weighing, handle the filter or crucible/filter with forceps or tongs only. 3) Place the glass fiber filter (i.e. Glass fiber filter discs, without organic binder, such as Millipore AP-40, Reeves Angel 934-AH, Gelman type A/E, or equivalent; Our lab uses 47 mm GF/F 0.7 micron retention) on the membrane filter apparatus. NOTE: Because of the physical nature of glass fiber filters, the absolute pore size cannot be controlled or measured. Terms such as “pore size”, “collection efficiencies” and “effective retention” are used to define this property in glass fiber filters. 4) For a 47 mm diameter filter, filter 100 mL of sample. If weight of captured residue is less than 1.0 mg, the sample volume must be increased to provide at least 1.0 mg of residue. If other filter diameters are used, start with a sample volume equal to 7 mL/cm of filter area and collect at least a weight of residue proportional to the 1.0 mg state above. NOTE: If filtering clear pristine water, start with 1 L. If filtering turbid water start with 100 mL.

NOTE: If during filtration of this initial volume the filtration rate drops rapidly, or if filtration time exceeds 5 to 10 minutes, the following scheme is recommended: Use an unweighed glass fiber filter affixed in the filter assembly. Add a known volume of sample to the filter funnel and record the time elapsed after selected volumes have passed through the filter. Twenty-five mL increments for timing are suggested. Continue to record the time and volume increments until the filtration rate drops rapidly. Add additional sample if the filter funnel volume is inadequate to reach a reduced rate. Plot the observed time versus volume filtered. Select the proper filtration volume as that just short of the time a significant change in filtration rate occurred.

5) Assemble the filtering apparatus and begin suction.

6) Shake the sample vigorously and quantitatively transfer the predetermined sample volume selected to the filter using a graduated cylinder. Pour into funnel. 7) Remove all traces of water by continuing to apply vacuum after the sample has passed through. 8) With suction on, wash the graduated cylinder, filter, non-filterable residue and filter funnel wall with three portions of distilled water allowing complete drainage between washing. Remove all traces of water by continuing to apply vacuum after water has passed through.

NOTE: Total volume of distilled rinse water used should equal no less than 50 mLs following complete filtration of sample volume.

9) Carefully remove the filter from the filter support.  10) Dry at least one hour at 103-105°C. Overnight drying ensures accurate filter weight.  11) Cool in a desiccator and weigh.  12) Repeat the drying cycle until a constant weight is obtained (weight loss is less than 0.5 mg).  

Calculations

TSS (mg/L) is calculated as follows:  1000 x (A-B) x (1000/C) = TSS

where A = weight of filter (or filter and crucible) + residue (mg), B = weight of filter (or filter and crucible) (mg), and C = amount of sample filtered (mL).

tss.csv